100G 1310nm 2KM QSFP28 CWDM4
- 100G 1310nm 2KM QSFP28 CWDM4 integrates four transmitters and receivers into one module. The central wavelengths of the 4CWDM channels are 1271, 1291, 1311 and 1331 nm as members of the CWDM wavelength grid defined in ITU-T G.694.2. In the transmitter side, the four lanes of optical data channels are optically multiplexed by the integrated optical multiplexer. In the receive side, the four lanes of optical data channels are optically de-multiplexed by the integrated optical de-multiplexer. Each data channel is recovered by a PIN photo-detector and trans-impedance amplifier, retimed.
- The product is designed with form factor, optical/electrical connection and digital diagnostic interface according to theQSFP28 Multi-Source Agreement (MSA) and compliant to CWDM4 MSA. Host FEC is required to support up to 2km fiber transmission.
- Compliant with CWDM4 MSA
- Supports 103.1Gb/s aggregate bit rate
- Integrated 4 CWDM lanes MUX/DEMUX
- Up to 2km transmission on single mode fiber (SMF) with FEC
- 4x25G electrical interface (OIF CEI-28G-VSR)
- Duplex LC receptacles
- Hot pluggable QSFP28 form factor
- Maximum power consumption 3.5W
- Operating temperature range：0℃~+70℃
- RoHS Compliant
- DDMI function available with internally calibrated mode
- I2C management interface
Optical Characteristics
Table 1. Transmitter Optical Characteristics
Parameter | Symbol | Minimum | Typical | Maximum | Unit | Notes |
|---|---|---|---|---|---|---|
Lane center wavelengths(range) | - | 1264.5
1284.5
1304.5
1324.5 | 1271
1291
1311
1331 | 1277.5
1297.5
1317.5
1337.5 | Nm | - |
Total Average Launch Power | Pout | - | - | 10.5 | DBm | - |
Average Launch Power per Lane | TXPx | -6.5 | - | 2.5 | DBm | - |
Extinction Ratio | ER | 3.5 | - | - | DB | - |
Sidemode Suppression ratio | SMSR | 30 | - | - | DB | - |
Relative Intensity Noise | RIN | - | - | -130 | DB/Hz | - |
Transmitter Reflectance | - | -12 | DB |
Transmitter Eye Mask Definition{X1, X2, X3, Y1, Y2, Y3} | {0.31, 0.4, 0.45, 0.34, 0.38, 0.4} | 1 |
Table 2.Receiver Optical Characteristics
Parameter | Symbol | Minimum | Typical | Maximum | Unit | Notes |
|---|---|---|---|---|---|---|
Lane center wavelengths(range) | 1264.5
1284.5
1304.5
1324.5 | 1271
1291
1311
1331 | 1277.5
1297.5
1317.5
1337.5 | Nm | - | |
Receive Saturation (OMA) per Lane | Rmax | 2.5 | - | - | - | - |
Unstressed Receiver Sensitivity (OMA) per Lane | Rxsens | - | - | -10 | DBm | 1，2，3 |
Receiver Reflectance | 2.5 | - | -26 | DBm | - | |
LOS
Optical De-assert
Optical Assert |
Pd
Pa |
3.4 |
- |
-11.6
-13.6 | DBm | - |
LOS Hysteresis | - | 0.5 | - | 5 | DB | - |
Note:
1. Hit ratio 5E-5.2. Measured with a PRBS 231-1 test pattern, @25.78Gb/s, BER<5E-5, for each channel.3. Minimum value is informative, equals min Tx OMA with infinite ER and max channel insertion loss.4. Power value and power accuracy are with all channels on.
1. Hit ratio 5E-5.2. Measured with a PRBS 231-1 test pattern, @25.78Gb/s, BER<5E-5, for each channel.3. Minimum value is informative, equals min Tx OMA with infinite ER and max channel insertion loss.4. Power value and power accuracy are with all channels on.
- Data Center Interconnect
- 100G CWDM4 applications with FEC
- Infiniband QDR and DDR interconnects
- Enterprise networking